Saturday, May 14, 2011

Sectonal Warping

I expect I've blogged about this before, but the question came up on one of the lists recently so I thought I share how I transfer the bouts from the back beam to behind the heddles ready for threading.

Here is the beam all ready to go - 30 sections.

Each bout is taped to a long stick.  Once all the sections are taped to the stick it is then 'threaded' through the beams.  This is why I have plastic covering the lower beam.  If it isn't covered the warp threads can catch on the sectional dividers on the lower beam and get pulled off the stick.

And here is the warp pulled through to just behind the heddles.  Now, Doug has modified the loom and it has an area on which the stick can sit.  Not all looms have this so one way to deal with the stick is to suspend it from the top of the loom.  When I'm using both beams, I tape the bottom beam's stick to the loom and suspend the top beam's stick from strings that hang from the castle of the loom.

This method won't necessarily work for everyone.  I don't make a cross, just peel the tape back and pull the threads from the tape for threading.  If you make a cross, you will probably insert the lease sticks into the cross and suspend the sticks from the castle.

4 comments:

Laritza said...

This is great! Thank you!

Bonnie said...

That sounds like a good method. I hate to use a cross. Thanks for sharing.

Geodyne said...

I'm pleased to see that this method is almost identical to my own! It seemed the logical way to thread after beaming sectionally. I tape the bouts to a lease stick and hang it from using strings suspended from the castle.

I find this method has the added bonus of providing the threads in convenient one-inch sections as well.

Unknown said...

This is wonderful and very timely for me as I just acquired a Cranbrook loom with a sectional beam (and warping wheel). Thank you so much for this.